Omnitracs LLC IVG2 User Manual
80-JE026-1 Rev. J
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
21
3. Put the unused power I/O cable end where the truck’s diagnostic connector was
located in the dash panel.
4. Route the power cable to the IVG display location.
5. Remove the Torx 10 screws from the door panel on back side of IVG display and
5. Remove the Torx 10 screws from the door panel on back side of IVG display and
connect the power cable to the IVG display. Ensure the cable latches solidly with the
ridge side of the connector facing outward.
ridge side of the connector facing outward.
6. Replace door panel and secure any excess cable using tie-wraps.