EISST LTD H500V2 User Manual

H500-CE/BK

SER

ANUAL

3 12

All the components and solder alloys used in the H500-CE/BK comply with RoHS directive

2011/65/EU, aimed at preventing all new electrical and electronic equipment placed on the

market in the European Economic Area from containing more than agreed levels of lead,

cadmium, mercury, hexavalent chromium, polybrominated biphenyls (PBB) and

polybrominated diphenyl ethers (PBBE).

The H500-CE/BK device complies with the CE marking directive and has been tested and

found to comply with the standards required by the Council Directive of RED Directive

2014/53/EU.

FCC STATEMENT

The H500-CE/BK device complies with part 15 of the FCC rules. Operation is subject to

the following two conditions: (1) this device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may cause

undesired operation. Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment under

Federal Communications

Commission’s rules.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

‐ Reorient or relocate the receiving antenna.