HCS Limited RC344A User Manual
3
Federal Communications Commission Interference Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirment. The device can be used
in portable exposure condition without restriction.
The device has been evaluated to meet general RF exposure requirment. The device can be used
in portable exposure condition without restriction.
Attention
that changes or modification not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note:
Note:
This product has been tested and found to comply with the limits for a Class B digital
device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This product generates, uses,
and
and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this product does cause
harmful
harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver s
connected.
—Consult the dealer or an experienced radio/TV technician for help.
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver s
connected.
—Consult the dealer or an experienced radio/TV technician for help.