NINGBO TOP OPTOELECTRONIC TECHNOLOGY CO. LTD SENSOR User Manual

 
TOP8232-LED-U-X-Sensor-EM, TOPA224-LED-U-X-Sensor-EM 
Note:"X" indicates CCT, between 2700K and 6500K 

 

 

 

 

1.  Electrical works have to be done by technical persons. 
2.  Disconnect the lamp from the power supply and let the lamp cool down before 

replacing the luminaire. 

3.  Never touch the luminaire when the power is on. 
4.  In case of damages, disconnect the lamp from the power supply. Do not try to 

repair the lamp on your own. Repair has to be done by technical persons or 
customer service. 

1.  Drill the fitting holes at the place of installation (wall/ ceiling), make sure, that 

no cables or other lines are passing in place of drilling. 

2.  Put the screws in the holes and fix the lamp to the mounting place. 
3. Insert the power cable (Type SJTW, 18AWG, min 80℃) connected to the 
connector, through the bushing in the opening . (By slightly pulling, the position of 
the washer can be optimised) 
4. When Connect the connector, Pay attention to the correct polarity

 L and N