YFC-BonEagle ELECTRIC CO. LTD. TXCC17 User Manual

1 Laser Light Projector

1 Ground Stake 
1 ground stake knob

1 Remote Control (3V CR2032 Battery Included) 
2 Piece Indoor stand

1 Instruction Manual

This product contains a built-in heater to 

protect the laser diodes (light source) from 

freezing. The heater must continue to 

receive power even when the light is turned 

off. Failure to maintain the electrical power to 

this product when temperatures drop below 

32°F can cause permanent failure of the 

laser diodes.

It may take up to 10 minutes after the laser 

has been turned on for it to achieve full 

brightness.

Plug the laser into an outdoor rated  

GFCI receptacle.

NOTE: When you first plug in the laser

• The default settings are:

•  Light Color: Red & Green Mode

•  Timer: 6 hours

• The laser light color may be

adjusted/set from the      button on 

the laser housing.

• The time setting may be changed by

pressing  

X

the

 X

 

Xs

button 

d

on 

d

the

d

 laser

body 

1. The laser will automatically turn on

at dusk each day and run for the

time programmed. It may take up to

10 minutes before the laser reaches

full brightness.

a. 

 IMPORTANT  NOTE: Once you

 have plugged in the laser to start

 using it, do not unplug it until

 done using it in that location.

2.  There are 3 different color display

options to choose from: RED &

GREEN (default), GREEN ONLY or

RED ONLY.

 a. RED & GREEN MODE

i. As mentioned, when the laser

is first plugged into an outlet,

this is the default setting.

 iii.

ii. RED & GREEN Mode

To manually select this mode, press the            button 

on the base of the laser until the laser projects red & 

green light. The laser must run through a full timer 

cycle, (one night's use) for the color mode you selected 

to be saved to repeat the next night. The color mode 

will automatically be saved even when the      button 

on the remote control is used to manually turn off the 

laser.

b. GREEN MODE

turns on at dusk.

ENGLISH FRONT-PAGE 1

©2017 Prime Wire & Cable, Inc. • City of Industry, CA 91789 • Service (888) 445-9955 • www.primewirecable.com

i. To manually select this mode,

press the       button on the

base of the laser until the laser 

projects green light. The laser

must run through a full timer

cycle, (one night's use) for the

color mode you selected to be 

saved to repeat the next night.

The color mode will 

automatically be saved even

when the      button on the

remote control is used to

manually turn off the laser

c.  RED  MODE 

i. To manually select this mode,

press the  button on the
base of the laser until the laser

projects red light. The laser 

must run through a full timer

cycle, (one night's use) for the 

color mode you selected to be 

saved to repeat the next night. 

The color mode will 

automatically be saved even

when the      button on the

remote control is used to

manually turn off the laser.

ci.  POWER  OFF  

 i.

 ii.

To turn off the laser using the 

remote control, press the       
     button. The laser will 

automatically turn on again the next 

evening at dusk in the last color 

and timer modes.
To turn off the laser manually, 

press the   button until the laser 

turns OFF. The laser will 

automatically turn on again the next 

evening at dusk in the last color 

mode programmed.

Battery Replacement:
Required Tool:

Small Phillips Screwdriver (not included)

Transmitter

TXCC17

manual