Dometic Corporation DC510B User Manual
A/00
dial switch
muti-function button
DC510B
Method of use
If vabration continues,the sensor will stand
by after motor closed;If vabrate happens
randomly,the motor will standby directly.
after the vabration reaches the set level,the awning
will open,then press
muti-function button
with a
beep hint,but do not release,then a beep again
as a hint of direction changed.
DC510B
When there is a vibration,reaching
setting point,DC510B launch three
times code.(30s quit the sense
statue after one order is transmitted)
pack up awning
when coltage is below 2.2V,it
will beep every 5s to remind
the battery changing.
there are ten level of intensity of vibration, increase from level 0 to
level 9 , and customers can set different class as per their demands.
Only when the vibration strength reaches the certain set value, can
the emitter be triggered and then emit signal to withdraw the roller
blinds. The emitter will emit signalthree times after it detects the
vibration, thus can make sure to withdraw the roller blinds.level 1
is the most sensitive one,level 9 is the least.level 0 sense nothing.
place the cover after operation,it will enter the normal working statue.
muti-function button:
0 level--set button,
5 level--up button,
9 level--down button.
All the parameters to the nameplate shall prevail
3V
control awning open and
close through vibration sensor
DC510B shake sensor
Set vibration grade:
Working principle
Installation location
power supply voltage: DC 3 V (two
batteries of number seven)
Working temperature：-20℃~55℃
Emission power：10 milliwatt
awning
open the outer shell,transmitters
have 0 ~ 9 grades switch which
used for dial the code for your choose
Match with E and R motors:
emitter should be already programmed.If emitter
is delete,then the wind-sun sensor is invalid
press the
muti-function
button
one times of
DC510B
The dial switch
is adjusted to 0
Match with DC136：
press the
muti-function
button
one times of
DC510B
The dial switch
is adjusted to 5
batteries
inside