Brainchild Electronic Co. Ltd. CA20 User Manual
5
Installing the camera
Follow the steps below to install the camera before use.
Step 1/6: Connect the camera to the accompanying USB
charger.
charger.
Connect the camera to the accompanying USB charger via the accompanying Micro-USB cable to
make sure the camera has enough power during installation and setup.
make sure the camera has enough power during installation and setup.
Step 2/6: Turn on the camera.
1. Straighten an end of a paper clip.
2. Use the tip of a paper clip to hold down the reset button (for about 3 seconds) until the LED
indicator lights up in blue and starts flashing.
Note: If you want to shut down the camera at any time, use the tip of a paper clip to hold down
the reset button until the LED indicator goes off.
Micro-USB port
Reset button