Zebra 01406-000 User Manual

Firmware
Firmware History

P1003643-001

TTP 1020™/TTP 1030™ Technical Manual

03/03/2009

Functions and features are being added from time to time affecting the firmware in the printer. 
The following table lists the changes of general interest.

Notice that the list may not contain the latest firmware versions. Please visit our web site for 
current information. 

FW version

Change

2.00

Support for text commands

2.10

Added hex-dump mode when starting printer with head up and switch 
pressed.

2.19

Fixing multiple page problems with new ring buffer

Fixed so that ESC b ... (Print bitmap) do not generate blank page

Adjusted the cut position so that a cut just after printing text will cut after 
the text and not in the text

Added EAN-13 bar code support

Added Calibrate Eject Length (ESC & 6 n) and calibration marks (at 40 and 
63 mm from top of page) on test print

Improved font loading and flash PROM erase/program-function

2.20

1. Now using parameter 37 & 38 as eject length when loading new 

paper.   (Especially useful for printer with long output nozzles)

2. Fixed checksum calculation when EAN-13 ends with zero.

2.46

1. EPP interrupt (INTR, pin 10) will now be sent on paper jam.
2. ID string length is now according to IEEE 1284-1994 (p.53)
3. All errors will now be cleared when head up switch is 

opened/closed.

4. The cutter will now be backed slowly if the cutter isn’t home at 

power-on/reset, instead of doing a full cut.

5. Parameter n49 now feed enough before cutting.
6. Eject calibration command <ESC>&<006> now works as 

described.

7. Lifting the head followed by holding the FF-button pressed while 

lowering the head will now print the self-test receipt.