Kingston Technology Genesis 8GB DDR3-2400MHz Kit KHX2400C11D3K4/8GX Data Sheet

Kingston's KHX2400C11D3K4/8GX is a kit of four 256M x 64-

bit (2GB) DDR3-2400 CL11 SDRAM (Synchronous DRAM)

1Rx8 memory modules, based on eight 256M x 8-bit DDR3

FBGA components per module. Each module kit supports

 XMP (Extreme Memory Profiles). Total kit capacity is

8GB. Each module kit has been tested to run at DDR3-2400 at

a low latency timing of 11-13-11 at 1.65V. The SPDs are

programmed to JEDEC standard latency DDR3-1333 timing of

9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers.

The JEDEC standard electrical and mechanical specifications

are as follows:

CL(IDD)

9 cycles

Row Cycle Time (tRCmin)

49.5ns  (min.)

Refresh to Active/Refresh

160ns  (min.)

Command Time (tRFCmin)

Row Active Time (tRASmin)

36ns (min.)

Power (Operating)

0.795 W* (per module)

UL  Rating

94 V - 0

Operating Temperature

0

o

 C to 85

o

 C

Storage Temperature

-55

o

 C to +100

o

 C

*Power will vary depending on the SDRAM used.

•

JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply

•

VDDQ = 1.5V (1.425V ~ 1.575V)

•

667MHz fCK for 1333Mb/sec/pin

•

8 independent internal bank

•

Programmable CAS Latency: 9, 8, 7, 6

•

Posted CAS

•

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

•

Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)

•

8-bit pre-fetch

•

Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]

•

Bi-directional Differential Data Strobe

•

Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)

•

On Die Termination using ODT pin

•

Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C

•

Asynchronous Reset

•

PCB : Height 1.18” (30mm) w/ heat spreader,

single sided component

Memory Module Specifi cations

Continued >>

8GB (2GB 256M x 64-Bit x 4 pcs.)
DDR3-2400 CL11 240-Pin DIMM Kit

•

JEDEC: DDR3-1333 CL9-9-9 @1.5V

•

XMP Profile #1: D3-2400 CL11-13-11 @1.65V

•

XMP Profile #2: D3-2133 CL11-12-11 @1.65V