Arctic Silver Céramique 2, 2.7g CMQ2-2.7G Leaflet
Product codes
CMQ2-2.7G
Arctic Silver Incorporated
MSDS # CMQ2_1
Page 1 of 2
SECTION 1: CHEMICAL PRODUCT AND COMPANY INFORMATION
Company Address:
9826 W. Legacy Ave.
Visalia, CA 93291
Company Address:
9826 W. Legacy Ave.
Visalia, CA 93291
Product Information: 559-740-0912
Medical Emergency Toll Free: 877-740-5015
Prepared by: Nevin House
Medical Emergency Alternate: 303-739-1110
Revision Date: March 17, 2011
Product Identification
Céramique 2 Tri-Linear Ceramic Thermal Compound
Product Code: CMQ2
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
Product Ingredient Information
Product Ingredient Information
CAS No.
Aluminum Oxide
1344-28-1
Boron Nitride
10043-11-5
Zinc Oxide
1314-13-2
Proprietary Oil Blend
Non-hazardous
SECTION 3: HAZARD IDENTIFICATION
Emergency Overview: Off white grease with slight odor. This product is nonflammable. Liquid will irritate eyes.
Potential Health Effects:
Potential Health Effects:
Eyes: This product is an eye and mucus membrane irritant.
Skin: Not expected to be a skin irritant. Repeated and prolonged skin contact could cause minor skin irritation.
Ingestion: No adverse effects expected.
Skin: Not expected to be a skin irritant. Repeated and prolonged skin contact could cause minor skin irritation.
Ingestion: No adverse effects expected.
Inhalation: No specific information available.
Pre-Existing Medical Conditions Aggravated by Exposure: Eye
Pre-Existing Medical Conditions Aggravated by Exposure: Eye
SECTION 4: FIRST AID MEASURES
Eyes: Immediately flush with large amounts of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Have eyes
examined by a Physician.
Eyes: Immediately flush with large amounts of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Have eyes
examined by a Physician.
Skin: Remove contaminated clothing and wash skin with soap and water. Get medical attention if irritation develops/persists. Wash clothes separately before reuse.
Ingestion: If appreciable quantities are swallowed, seek medical advice.
Inhalation: Not likely route of exposure. If inhaled and irritation occurs, remove to fresh air. If irritation persists, call a Physician.
Ingestion: If appreciable quantities are swallowed, seek medical advice.
Inhalation: Not likely route of exposure. If inhaled and irritation occurs, remove to fresh air. If irritation persists, call a Physician.
SECTION 5: FIRE FIGHTING MEASURES
Flash Point: > 600
Flash Point: > 600
F (Setaflash)
LEL/UEL: NA (% by volume in air)
Extinguishing Media: Use carbon dioxide or dry chemicals for small fires, aqueous foam or water for large fires involving this material.
Fire Fighting Instructions: Remove all ignition sources. Closed containers may rupture due to build-up of pressure when exposed to extreme heat. Fight fire from a
safe distance. As in any fire, wear self-contained breathing apparatus (pressure demand, OSHA/NIOSH approved or equivalent) and full protective gear.
Fire Fighting Instructions: Remove all ignition sources. Closed containers may rupture due to build-up of pressure when exposed to extreme heat. Fight fire from a
safe distance. As in any fire, wear self-contained breathing apparatus (pressure demand, OSHA/NIOSH approved or equivalent) and full protective gear.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Large Spills: Remove all sources of ignition (sparks, open flames, etc.). Wear self-contained breathing apparatus and appropriate personal protective equipment.
Ventilate area and contain spill with sand or other absorbent material. Collect spill by scooping up liquids and absorbent material and place in a sealed metal container
for proper disposal. Do not flush to sewer. Prevent material from entering storm sewers, ditches that lead to waterways and ground.
Small Spills: Absorb spill with absorbent material, then place in a sealed metal container for proper disposal.
Large Spills: Remove all sources of ignition (sparks, open flames, etc.). Wear self-contained breathing apparatus and appropriate personal protective equipment.
Ventilate area and contain spill with sand or other absorbent material. Collect spill by scooping up liquids and absorbent material and place in a sealed metal container
for proper disposal. Do not flush to sewer. Prevent material from entering storm sewers, ditches that lead to waterways and ground.
Small Spills: Absorb spill with absorbent material, then place in a sealed metal container for proper disposal.
SECTION 7: HANDLING AND STORAGE
Overheating may cause container to rupture. Use explosion proof electrical equipment. Containers must be kept closed and ventilation provided to prevent vapor
concentration build-up. Store in a cool dry place. Do not breathe vapor or get liquid in eyes, or on skin and clothing. Keep away from heat or sources of ignition.
Check all containers for leaks. Wear protective clothing as in section above. Avoid prolonged breathing of vapors or contact with skin. Ensure that all equipment is
grounded to prevent static discharge. Containers of this material may be hazardous when emptied due to solid or vapor residue. All hazard precautions given in this
data sheet must be observed for empty containers.
Overheating may cause container to rupture. Use explosion proof electrical equipment. Containers must be kept closed and ventilation provided to prevent vapor
concentration build-up. Store in a cool dry place. Do not breathe vapor or get liquid in eyes, or on skin and clothing. Keep away from heat or sources of ignition.
Check all containers for leaks. Wear protective clothing as in section above. Avoid prolonged breathing of vapors or contact with skin. Ensure that all equipment is
grounded to prevent static discharge. Containers of this material may be hazardous when emptied due to solid or vapor residue. All hazard precautions given in this
data sheet must be observed for empty containers.
KEEP OUT OF REACH OF CHILDREN
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Guidelines:
Exposure Guidelines:
CHEMICAL NAME
ACGIH TLV
OSHA PEL
ACGIH STEL
Aluminum Oxide 10 mg/m3 (dust) 10 mg/m3 (dust) NA
Boron Nitride 10 mg/m3 (dust) 10 mg/m3 (dust) NA
Zinc Oxide 10 mg/m3 (dust) 15 mg/m3 (dust) 10 mg/m3
Proprietary Oil Mix NA NA NA
NFPA and HMIS Codes:
Boron Nitride 10 mg/m3 (dust) 10 mg/m3 (dust) NA
Zinc Oxide 10 mg/m3 (dust) 15 mg/m3 (dust) 10 mg/m3
Proprietary Oil Mix NA NA NA
NFPA and HMIS Codes:
NFPA
HMIS
Health
0
0
Flammability
1
1
Reactivity
0
0
Personal Protection
--
B
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Off-White Grease
Physical State: Off-White Grease
Solubility in Water: <2.0%
Odor: Slight Odor
Specific Gravity: 2.6-2.7
pH: NA
Evaporation Rate: slower
Vapor Pressure: NA
(Butyl acetate=1)
(Air 1)
Boiling Range: NA
Vapor Density: NA
(Water =1)
(Air = 1)
Percent Volatile: < 0.1
SECTION 10: STABILITY AND REACTIVITY INFORMATION