Asrock K7VT4A PRO User Manual

2 2

AMIBIOS SETUP UTILITY - VERSION 3.31a

Main

Type
Cylinders
Heads
Write Precompensation
Sectors
Maximum Capacity
LBA Mode
Block Mode
Fast Programmed I/O Modes
32 Bit Transfer Mode
Ultra DMA Mode

[

Setup Help

]

F1:Help

Esc:Previous Menu

F9:Setup Defaults
F10:Save & Exit

+/-:Change Values

Enter:Select

Sub-Menu

:Select Item

Primary IDE Master

Off
Off
Auto
Off
Auto

Select how to set the
parameters of drive,

Or
Select [AUTO] to set
all HDD parameters
automatically.

Auto

To set the type of the IDE device, first, please select “IDE Devices” on Main

menu and press <Enter> to get into the sub-menu. Then, select among

“Primary IDE Master”, “Primary IDE Slave”, “Secondary IDE Master”, and

“Secondary IDE Slave” to make configuration of its type. Below are the

configuration options.

[USER]: It allows user to manually enter the number of cylinders, heads,

and sectors per track for the drive.

Before attempting to configure a hard disk drive, make sure you

have the correct configuration information supplied by the drive

manufacturer. Incorrect settings may cause the system to fail

to recognize the installed hard disk.

[Auto]: Select [Auto] to automatically detect hard disk drive. If auto-

detection is successful, the BIOS Setup automatically fills in the

correct values for the remaining fields on this sub-menu. If the auto-

detection fails, it may due to that the hard disk is too old or too new.

If the hard disk was already formatted on an older system, the BIOS

Setup may detect incorrect parameters. In these cases, select [User]

to manually enter the IDE hard disk drive parameters.

After entering the hard disk information into BIOS, use a disk utility,

such as FDISK, to partition and format the new IDE hard disk

drives. This is necessary so that you can write the data into or

read the data from the installed hard disk. Please make sure to set

the partition of the Primary IDE hard disk drives to make them

active.