Festool PM561556 User Manual
24
TS 55 REQ
Troubleshooting
Symptom
Possible Causes
Motor does not start
►
Check that the cord is properly plugged into an outlet.
►
Make sure the Plug-it connector is properly inserted and fully tightened.
►
Make sure the outlet has power. Check the circuit breaker or try another outlet.
►
If used with a Festool dust extractor, make sure the selector switch is pointing to “Auto”.
The auxiliary outlet on the dust extractor has power only when the selector is at Auto.
►
Inspect the power cord (including extension cords) for damage or missing prongs.
►
The motor brushes may have worn and need replacement.
The saw makes a
“Growling” sound when
it is first turned on or
idling.
►
This is normal operation. Refer to
page 15
for more information.
The saw makes wavy
cuts
►
Make sure the guide rail gib cams are properly adjusted.
►
Inspect the blade for damage.
►
Make sure the sole plate is not rocking on the guide rail.
►
Keep the blade depth consistent during the cut; don’t raise and lower the blade.
►
Forcing an ATB-type blade into the cut too fast can cause the blade to deflect.
Saw cuts are burning
►
Make sure to use the correct blade for the material.
►
Make sure the blade is sharp.
►
Make sure the blade is installed correctly (not turning backward).
►
Reduce the motor speed.
►
If possible, increase the blade depth.
►
Increase your feed speed.
Excessive chipping on
the lower edge of the cut
►
Make sure to use the correct blade for the type of material and type of cut.
►
A very shallow blade depth can cause chipping on the underside if the teeth are barely
protruding below the surface. Increase the blade depth.
►
The blade toe-in may be incorrect. Refer to
page 22
for more information.
Excessive chipping on
the top edge of the cut
►
Make sure to use the correct blade for the type of material and type of cut.
►
Inspect the splinter guard. Make sure it is flush with the cut line for its entire length.
►
Materials prone to splintering may splinter more if the blade is set too deep.
The sawblade fails to
retract after a cutting
operation
►
The saw requires immediate service, and should be removed from operation. Contact
Festool or your authorized Festool service provider.