Avision IS25 000-0698-02G Leaflet

 

1

 

     

 

   

 

Power cable 

Cleaning 
Swab 

 

USB Cable 

 

Calibration Card 

 

This scanner provides you flexibility to 
start instant scans without connecting it 
to a computer or you may start 
advanced scans by installing the 
software and connecting it to a 
computer.  
To start instant scan and store your 
images to your memory card or USB 
flash drive, follow the instructions in 
below to setup the scanner and start the 
battery charging. 

 

 

1.1  Open the battery cover underneath the 

scanner. 

1.2  Load the battery into the battery 

container. Make sure the battery is 
loaded in the correct position. Only use 
the battery model provided with the 
scanner. 

 

 

 

Important: 
z

 

Allow the battery to charge for at least 6 
hours. The battery must be fully 
charged before first-time use. 

z

 

Please use the included power adapter 
WA-10H05 made by APD.   

2.1  Turn off your scanner by moving the 

POWER knob to the “OFF” position. 

 

2.2  The battery can be charged either 

through the supplied power adapter or 
through the computer via the USB cable. 

Through the power adapter: Plug the small 
end of the USB power cable to the mini USB 
port of the scanner. Plug the other end to an 
electric outlet. 
Through the computer: Insert the mini end 
of the USB cable to the mini USB port of the 
scanner. Turn on your computer, and then plug 
the other flat ends into two USB ports on your 
computer. 

 

2.3    During the charging process, the battery 

LED light will be lit in orange. When the 
power capacity is full, the battery LED 
light will be extinguished.

 

 

 

Insert the memory card with the copper 
strips face down in the SD slot of the scanner. 

 

If you have a USB flash drive, you can 
connect it to the USB port of the scanner 
instead of using a memory card. 

 

 

4.1  Move the POWER knob to any number 

between “1” and “5” to turn on the 
scanner.   

 

4.2  The System LED will be first lit in red 

and then lit in green steadily. This 
indicates the scanner is in ready status. 

 

 

 

5.1  Turn the operation mode to 

“SD/Flash” at the rear of the 
scanner as indicated. 

 

5.2  To save your images in JPEG file 

format, turn the POWER knob to 
“1”.  
To save images in PDF file format, 

turn the POWER knob to “2”.   

To save your images in TIFF file 

format, turn the POWER knob to 
“3”. 

5.3  Insert your document FACE UP 

into the feeding slot. 

5.4  Align your document to the left 

edge of the feeding slot. 

 

5.5  The scanner starts scanning the 

original when the paper has been 
fed into the feeding slot. 

5.6  When scanning is finished, the 

image is saved in the memory card 
or your USB flash drive. (If 
JPEG/TIFF is selected, a folder and 
a subfolder “DCIM\100Photo” 
will be created. If PDF is selected, a 
folder and subfolder 
“DCIM\100DOC” will be created.)   

Important: 
To ensure the best image quality, please 
insert a photo to the supplied plastic 
sheath before scanning.