Cisco T3 kit CAB-T3-KIT1= User Manual
Product codes
CAB-T3-KIT1=
Page 25 of 28
78-19803-02 Cisco TelePresence System T3 System Assembly Guide, December 2011
Lids and cover plates
1.
Insert the cover in the table top module, as shown.
2.
Remove the protective film along the edges on the
center cover plate parts. Assemble both units as
shown. Use 3 pcs. M6×10 screws and 1 pc. M6 nut for
this, as well as Shimsplate cover-connection and the
Joining plate with guide-pin cover-connection.
center cover plate parts. Assemble both units as
shown. Use 3 pcs. M6×10 screws and 1 pc. M6 nut for
this, as well as Shimsplate cover-connection and the
Joining plate with guide-pin cover-connection.
3.
Before you insert the two plates that you now have, spend
some time on figuring out how the two will join. This will
make the process of inserting them correctly a lot easier.
some time on figuring out how the two will join. This will
make the process of inserting them correctly a lot easier.
4.
Insert the two center cover plate halves as shown.
5.
Starting with the System end, insert cover plates, as
shown, on top of the floor structure.
shown, on top of the floor structure.
1
2
6.
Snap the column covers into place and fasten with the
screws that were removed when the covers were taken
off.
screws that were removed when the covers were taken
off.
7.
Mount the door and lock the door. Keep the keys in a
safe place. Observe that all locks use the same key.
safe place. Observe that all locks use the same key.
Tip!
When cleaning the table top use lukewarm water with
a mild detergent. Wipe the table clean with the enclosed
cloth found in the Accessories box. Use of other cloths is
not recommended.
cloth found in the Accessories box. Use of other cloths is
not recommended.
8.
Put the Cable covers in place, as shown.