AMX AVB-WP-TX-MULTI-DXLINK FG1010-320-BL Data Sheet
Product codes
FG1010-320-BL
© 2013 AMX. All rights reserved.
DATA SHEET
DXLink
TM
Multi-Format Wallplate
Transmitters
AVB-WP-TX-MULTI-DXLINK (FG1010-320-BL, FG1010-320-WH)
Overview
The DXLink Multi-Format Wallplate Transmitter sends analog or digital video
including HDMI/HDCP, along with embedded audio or supplemental analog audio
up to 100 meters to an Enova DGX Matrix Switcher, compatible Enova DVX All-In-
One Presentation Switcher, or directly to a DXLink Receiver. It receives power from
the Enova DGX or Enova DVX (3155HD or 2155HD) over the twisted pair cable and
features both a multi-format analog port to support legacy devices and an HDMI
port to support newer digital devices.
Common Applications
Mount the DXLink Multi-Format Wallplate Transmitter in the wall or lectern to connect guest equipment and send
audio and video signals across the room, on the other side of the house or in a classroom down the hall. Since it is
powered remotely, the wallplate can be installed virtually anywhere.
Features
Only One Cable – Send audio and video, while passing Ethernet signals and power over one twisted pair
cable
cable
Multi-Format Analog Port and HDMI Port – Supports legacy analog signals - RGBHV, Component, S-Video,
and Composite, and digital HDMI/HDCP, DisplayPort++ and DVI signals
and Composite, and digital HDMI/HDCP, DisplayPort++ and DVI signals
Send HDMI signals up to 100 meters – Extend the reach of the HDMI signals far beyond the capabilities of
typical HDMI cabling
typical HDMI cabling
Standard Twisted Pair Cable – Save time and effort in installation by leveraging cost effective twisted pair
cable, see the Cabling for Success with DXLink white paper for more details
cable, see the Cabling for Success with DXLink white paper for more details
Power over DXLink* Enabled – Designed for use with Enova DGX or DVX systems with DXLink inputs, PS-POE-
AT-TC (FG423-84) or PDXL-2 (FG1090-170) to provide remotely located Power over DXLink (requires firmware
v1.2.40 or above)
AT-TC (FG423-84) or PDXL-2 (FG1090-170) to provide remotely located Power over DXLink (requires firmware
v1.2.40 or above)
DXLink Direct Connection – When receiving Power over DXLink* from the PS-POE-AT-TC or PDXL-2, DXLink
Wallplates can be connected directly to a DXLink Receiver for a point-to-point solution
Wallplates can be connected directly to a DXLink Receiver for a point-to-point solution