Sharp DLP data video projector XG-C68X User Manual

▼Keycode input box

',", \, |
buttons

', ", \, |
buttons

• The language preset at the factory is English.

If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page 

• The power indicator illuminates red, and

the projector enters the standby mode.

ON

• The power indicator illuminates green.

After the lamp indicator illuminates, the
projector is ready to start operation.

Note

• The lamp indicator illuminates, indi-

cating the status of the lamp.

Green: The lamp is on.
Green blinking: The lamp is

warming up or
shutting down.

• If the projector is put into the standby

mode and immediately turned on
again, the lamp indicator may take
time to illuminate.

• When controlling the projector using

RS-232C commands from a com-
puter, wait for at least 40 seconds
after the power has been turned on,
and then transmit the commands.

• Enter the keycode.

Note

• When entering the keycode, press

the buttons previously set on the
projector or the remote control.

• When “Anti-Theft” is set, enter the

keycode or the input display will not ap-
pear. Even when the signal is input, the
display will not appear. (see page