Micron 128GB RealSSD C400 SED MTFDDAK128MAM-1J12 User Manual
Product codes
MTFDDAK128MAM-1J12
Reliability
Micron’s SSDs incorporate advanced technology for defect and error management.
They use various combinations of hardware-based error correction algorithms and
firmware-based static and dynamic wear-leveling algorithms.
They use various combinations of hardware-based error correction algorithms and
firmware-based static and dynamic wear-leveling algorithms.
Over the life of the SSD, uncorrectable errors may occur. An uncorrectable error is de-
fined as data that is reported as successfully programmed to the SSD but when it is read
out of the SSD, the data differs from what was programmed.
fined as data that is reported as successfully programmed to the SSD but when it is read
out of the SSD, the data differs from what was programmed.
Table 6: Uncorrectable Bit Error Rate
Uncorrectable Bit Error Rate
Operation
<1 sector per 10
15
bits read
READ
Mean Time Between Failures
Mean time between failures (MTBFs) for the SSD can be predicted based on the compo-
nent reliability data using the methods referenced in the Telcordia SR-332 reliability
prediction procedures for electronic equipment.
nent reliability data using the methods referenced in the Telcordia SR-332 reliability
prediction procedures for electronic equipment.
Table 7: MTBFs
Density
MTBF (Operating Hours)
128GB
1.2 million
256GB
1.2 million
512GB
1.2 million
Note: 1. The product achieves a mean time between failure (MTBF) of 1.2 million hours, based
on population statistics not relevant to individual units.
Endurance
Endurance for the SSD can be predicted based on the usage conditions applied to the
device, the internal NAND component cycles, the write amplification factor, and the
wear-leveling efficiency of the drive. The table below shows the drive lifetime for each
SSD density based on predefined usage conditions.
device, the internal NAND component cycles, the write amplification factor, and the
wear-leveling efficiency of the drive. The table below shows the drive lifetime for each
SSD density based on predefined usage conditions.
Table 8: Drive Lifetime
Density
Drive Lifetime (Total Bytes Written)
128GB
72TB
256GB
72TB
512GB
72TB
Notes: 1. Total bytes written calculated with the drive 90% full.
2. Access patterns are 50% sequential and 50% random and consist of the following: 5%
are 4k; 5% are 8k; 10% are 16k; 10% are 32k; 35% are 64K; and 35% are 128k.
3. GB/day can be calculated by dividing the total bytes written value by (365 × number of
years). For example: 72TB/5 years/365 days = 40 GB/day for 5 years.
C400 2.5-Inch NAND Flash Self-Encrypting Drive SSD
Reliability
PDF: 09005aef848722e9
realssd_c400_2_5_sed.pdf - Rev. A 09/11 EN
realssd_c400_2_5_sed.pdf - Rev. A 09/11 EN
8
Micron Technology, Inc. reserves the right to change products or specifications without notice.
©
2011 Micron Technology, Inc. All rights reserved.