Moog Videolarm Fusion FCH11C8WQ User Manual

MOUNTING

BRACKET

ASSEMBLY

POLE

NYLON

TIE

 MOUNTING

HOOKS

& WING NUTS

MOUNTING

HOOKS

& WING NUTS

POLE

NYLON

TIE

MOUNTING HOOKS

& WING NUTS

TOP

CHAIN

BOTTOM

CHAIN

Attaching the Mounting Bracket
Assembly to a Pole

A) Thread NYLON TIE thru Tie Slots and around 
     pole to TEMPORARILY hold the Mounting
     Bracket Assembly in place on pole.

B) Apply a bead of THREAD LOCKING
     COMPOUND onto each Hook.
     Insert (4) MOUNTING CHAIN
     HOOKS and attached
     WING NUTS through
     the most appropriate top
     & bottom Bracket
     Assembly slots.

C) With Hooks fully extended, attach
     one end of MOUNTING CHAIN to
     one of the Top Mounting Hooks.
     Pull the Chain tight to Pole and then
     attach shortest link to corresponding
     Top Hook. (To keep chain from being
     jammed by the hook, place link on
     outside of the Hook.) Spin Wing Nuts
     down evenly, enough to keep the
     Assembly in place.

D) Repeat process for Bottom Hooks
     and Chains.

E) Hand tighten all Wing Nuts evenly,
     ensuring Mounting Bracket Assembly
     is difficult to rotate on the Pole. Then
     “tap” the chain sharply to remove any
     slack and fully re-tighten all Wing Nuts.

  
    IMPORTANT: HAND TIGHTEN ONLY.
    EXCESS TIGHTENING MAY CAUSE
    HOOK ENDS TO SPREAD.

TIE SLOT

MOUNTING

BRACKET

ASSEMBLY

SLOTS

MOUNTING

BRACKET

ASSEMBLY

MOUNTING

HOOKS

& WING NUTS

THREAD LOCKING

COMPOUND

(On All Hook Threads)