Intel G640T CM8062301002204 User Manual
Product codes
CM8062301002204
Processor Configuration Registers
230
Datasheet, Volume 2
2.18.5
GSTS_REG—Global Status Register
This register reports general remapping hardware status.
B/D/F/Type:
0/0/0/GFXVTBAR
Address Offset:
1C–1Fh
Reset Value:
0000_0000h
Access:
RO, RO-V
Size:
32 bits
BIOS Optimal Default
000000h
Bit
Attr
Reset
Value
RST/
PWR
Description
31
RO-V
0b
Uncore
Translation Enable Status (TES)
This field indicates the status of DMA-remapping hardware.
0 = DMA-remapping hardware is Not enabled
This field indicates the status of DMA-remapping hardware.
0 = DMA-remapping hardware is Not enabled
1 = DMA-remapping hardware is enabled
30
RO-V
0b
Uncore
Root Table Pointer Status (RTPS)
This field indicates the status of the root- table pointer in
This field indicates the status of the root- table pointer in
hardware.
This field is cleared by hardware when software sets the SRTP field
This field is cleared by hardware when software sets the SRTP field
in the Global Command register. This field is set by hardware when
hardware completes the 'Set Root Table Pointer' operation using
the value provided in the Root-Entry Table Address register.
29
RO
0b
Uncore
Fault Log Status (FLS)
0 = Cleared by hardware when software Sets the SFL field in the
0 = Cleared by hardware when software Sets the SFL field in the
Global Command register.
1 = Set by hardware when hardware completes the 'Set Fault Log
Pointer' operation using the value provided in the Advanced
Fault Log register.
28
RO
0b
Uncore
Advanced Fault Logging Status (AFLS)
This field is valid only for implementations supporting advanced
This field is valid only for implementations supporting advanced
fault logging. It indicates the advanced fault logging status:
0 = Advanced Fault Logging is Not enabled.
0 = Advanced Fault Logging is Not enabled.
1 = Advanced Fault Logging is enabled.
27
RO
0b
Uncore
Write Buffer Flush Status (WBFS)
This field is valid only for implementations requiring write buffer
This field is valid only for implementations requiring write buffer
flushing. This field indicates the status of the write buffer flush
command. It is:
• Set by hardware when software sets the WBF field in the
Global Command register.
• Cleared by hardware when hardware completes the write
buffer flushing operation.
26
RO-V
0b
Uncore
Queued Invalidation Enable Status (QIES)
This field indicates queued invalidation enable status.
0 = Disabled. Queued invalidation is not enabled.
This field indicates queued invalidation enable status.
0 = Disabled. Queued invalidation is not enabled.
1 = Enabled. Queued invalidation is enabled.
25
RO-V
0b
Uncore
Interrupt Remapping Enable Status (IRES)
This field indicates the status of Interrupt-remapping hardware.
0 = Interrupt-remapping hardware is Not enabled
This field indicates the status of Interrupt-remapping hardware.
0 = Interrupt-remapping hardware is Not enabled
1 = Interrupt-remapping hardware is enabled
24
RO-V
0b
Uncore
Interrupt Remapping Table Pointer Status (IRTPS)
This field indicates the status of the interrupt remapping table
This field indicates the status of the interrupt remapping table
pointer in hardware.
This field is cleared by hardware when software sets the SIRTP field
This field is cleared by hardware when software sets the SIRTP field
in the Global Command register. This field is set by hardware when
hardware completes the set interrupt remap table pointer
operation using the value provided in the Interrupt Remapping
Table Address register.