takeMS MiniSD 2GB MS2048SDC-SD1R Leaflet
Product codes
MS2048SDC-SD1R
Mini - Secure Digital Card
Order No.: MSXXXSDC-SD1
Web: www.takems.com
Tel: +49-7667-9414-0
Fax: +49-7667-9414-444
Storage Capacities:
Item
Description
Physical Dimension Specifications
(Units in mm)
Type Measurement
Length 21,5mm+/- 0,1mm
Width 20,0mm+/- 0,08mm
Thickness 1,4mm+/- 0,1mm
Weight 1,0g max.
Power Consumption
Read: <30mA
Write: <30mA
Standby: <100uA
Performance
MTBF: 1,000,000 h
Data Transfer Rate up to 160x
Sustained Read up to 40x
Sustained Write up to 30x
* Depending on system config.
Env. Specs.
Temperature Operating -10°C to 55°C
Humidity Operating 8% to 95%, non-condensing
Vibration Operating 15G peak-to-peak Max.
Operating 40G @11ms.
SD-
Mode
SPI-
Mode
Pin
Name
IO type
1
Description
Name
IO Type
Description
1
CD/ DAT3
2
I/O /PP
3
Card Detect/Data Line [Bit 3] CS
I
Chip Select (Active Low)
2
CMD
PP
Command/Response
DI
I
Data In
3
VSS
1
S
Supply Voltage Ground
VSS
S
Supply Voltage Ground
4
Vdd
S
Supply Voltage
Vdd
S
Supply Voltage
5
CLK
I
Clock
SCLK
I
Clock
6
VSS
2
S
Supply Voltage Ground
VSS
2
S
Supply Voltage Ground
7
DAT0
I/O /PP
Data Line (Bit 0)
DO
O/PP
Data Out
8
DAT1
I/O /PP
Data Line (Bit 1)
RSV
9
DAT2
I/O /PP
Data Line (Bit 2)
RSV
10
NC
4
I/O /PP
For Future Use
NC
For Future Use
11
NC
4
I/O /PP
For Future Use
NC
For Future Use
1. S: Power supply / I: input / O: Output using push-pull drivers / PP: I/= using push-pull drivers
2. The extended DAT Lines (Dat1-Dat3) are input on power up. They start to operate as Dat lines after SET_BUS_WIDTH command.
The Host shall keep its own Dat1-Dat3 lines in input mode, as well, while they are not used. It is defined so, in order to keep
compatibility to MultiMedia Cards.
3.
After power up this line is input with 50Kohm pull-up (can be used for card detection or SPd mode selection). The pull-up should be
diconnected by user,during regular data transfer, with SET_CLR_CARD_Detect (ACMD42) command.
4. NC
4. NC