Kurth Electronic KE7207 0.49452-7 Leaflet

Product codes
0.49452-7
Page of 2
®
Ethernet Performance Tester
KE7200
Fast and easy test of LAN Cabling, IP-Function, 
and Power over Ethernet:
˜
Wire-Mapping and precise fault location
˜
Measures cable lengths up to 150 m (TDR)
˜
Displays line voltage
˜
HUB-Blink for port identification
˜
High power trace tone signal to use with optional 
PROBE 310
˜
Power over Ethernet Test (IEEE802.3af)
˜
Detects network speed 10/100/1000 Mbit
˜
Tests LAN using static IP or DHCP
˜
List of active LAN devices and continuous Ping Test
˜
Identifies up to 32 active Remote Units
˜
Master und Remote over voltage protected up 
to 100 V AC
˜
Stores data and print out of test reports
The  KE7200  Ethernet  Performance  Tester  is  an  easy-to-use  tool  that  verifies  and  troubleshoots  all  types  of  Ethernet  cable 
installations, from essential copper wiring tests to active IP PING. Advanced copper test capabilities include active TDR for cable 
length and detection of split pairs even on jumpers (down to 2 meter or 6 feet). The KE7200 even shows multiple faults simultaneously.
Essential Copper Tests
KE7200
 tests for wire continuity, opens, shorts, miswires and split pairs and shows test results on the easy to read graphical display 
with backlight. The length of the cable and distance to fault (short or open) is also shown by the KE7200.
Cabel Trace
Active Testing
The KE7200 Ethernet Performance Tester finds and displays network-connected devices with their IP/MAC addresses. It works with 
either DHCP or fixed IP services. Connected devices can be PINGed one by one with selectable frame lengths and CRC errors are 
displayed if they occur.
Power over Ethernet (PoE)
The KE7200 can perform a Power over Ethernet Test (IEEE802.3af). KE7200 not only checks for ability of Power over Ethernet, it 
detects the type available and what power level is supported. PoE is appearing more commonly as devices like wireless access points 
(WAP), IP cameras and IP telephones grow in popularity. Mismatches between equipment and power supply can cause a variety of 
problems.
Data storage
Setup 
The KE7200 has 16 predefined wiring shemes further shemes are user settable via device. Cable types are also predefined and 
further types can be created by the user via device.
Port identification via Link-Blink function and settabel trace tones for locating cables with capacitive Probe (optional PROBE310).
Cable measurements and information about Ethernet performance can be stored and transfered to a PC or laptop. The included 
Windows PC-Software Ethernet-Manager gives clear indication about cable length, cable faults and allows the creation of test reports. 
05/12 - 
Product design and specifications subject to change without notice. 
All trademarks belong to their respective companies.
KE7010
Remote