Liebert MPXIPC-NXH30XXX User Manual

The RPCBDM (Basic Display Module) can be mounted in the rack with either the included hardware 

or with a cable tie through the slot on the back of the module (see Figure 17). Either method permits 

moving the RPCBDM to a different place in the same rack or to another rack.

• Spring nut M5: 1
• Spacer sleeve: 1
• Special MPX screw: 1
• Cable clip: 1

• Flat-blade screwdriver

1. Determine the mounting location in the rack.
2. Insert a spring nut into a T-slot on the frame member where the RPCBDM will be installed (refer 

to Figure 9).

3. Insert the Liebert

®

 MPX

™

 screw into the spacer sleeve.

4. Insert the Liebert MPX screw into the spring nut and tighten securely with the screwdriver.
5. Hang the RPCBDM on the Liebert MPX screw with the hooded mounting slot on the back of the 

RPCBDM (see Figure 17).

6. Connect the RPCBDM to the Liebert RPC

™

 with an Ethernet cable. 

Be certain to connect the cable to the correct port on the Liebert RPC (see Figure 18).