Toshiba W-705 User Manual

1 8

To add channels

To erase channels

Adding or erasing channels

Adding channels
If a desired channel cannot be scanned
automatically because of a weak signal, it can be
added to the memory.
Erasing channels
You can erase a stored channel from the memory
if it is unnecessary.

1) Follow steps 

 to 

 of “Incoming Antenna/CATV

Signals”.

2) Select “ADD CH” or “ERASE CH” using 

UP or CURSOR DOWN.

3) Enter a channel number of 1 to 125 using

number buttons.
For more than 100 number, first press 

100.

For CATV channels, refer to the chart below.
(For other orders, check with your cable
company.)

4) Repeat steps 2) and 3) to add or erase

channels as necessary.

5) Press 

PROG to exit.

Selecting stored channels

Once the active channels have been stored, you
can select the channels in two ways below.
Number buttons
To enter digits of the channel number.
• For one-digit number, enter 0 before.
• For more than 100 number, first press 

100.

• Each 

number button needs to be pressed

within 2 seconds.

CH
To shift up or down the stored channel numbers.

Cable Box/DSS Output Channel
Setting

To set the Cable Box/DSS output Channel on the
VCR.

1) Press 

PROG to display the MENU screen.

2) Select “PRESET” using 

CURSOR RIGHT or

CURSOR LEFT, and press ENTER.

3) Select “CABLE BOX/DSS” using 

CURSOR UP or

CURSOR DOWN, and press ENTER.

4) Select “NO”, “C.BOX” or “DSS” using 

RIGHT or CURSOR LEFT according to your
connection type.

5) If set to “C.BOX” or “DSS”, select “OUTPUT CH”

using 

CURSOR UP  or CURSOR DOWN. Then

enter the output channel number of your cable
box (Usually 3 or 4, check the rear of the cable
box.) or line input mode “L1” using the 

SELECT  button according to your connection.

6) Press 

PROG to exit.