Toshiba Strata DK Admin User Manual
17
Installing DKBackup
Installing DKBackup
3
Step 1: Check System Requirements
For optimum performance, run DKBackup on a personal computer with the following
minimum specifications:
minimum specifications:
♦
IBM-compatible 386/486 personal computer or higher level
♦
20MB or larger hard drive
♦
CD-ROM or 3.5" 1.44KB high-density floppy drive
Note
DKBackup software is distributed on a CD-ROM disk. Installation can be performed
using the CD-ROM disk or from floppy disk(s) copied from the CD-ROM DKBackup
install program.
using the CD-ROM disk or from floppy disk(s) copied from the CD-ROM DKBackup
install program.
♦
VGA or SVGA monitor preferred
♦
640KB RAM (minimum)
♦
Microsoft
MS-DOS
6.22, Windows
3.11 or higher (Windows 95, 98 or Windows
NT
4.0 recommended).
♦
A laser printer is recommended
♦
For network users, a minimum of 2MB of disk space is required for each person using
DKBackup on the network.
DKBackup on the network.
♦
DKBackup hardware key (green or red)
DKBackup is a MS-DOS program that can be installed and run under Microsoft
Windows 3.11, 95, 98, NT or MS-DOS (6.22 or higher)
Windows 3.11, 95, 98, NT or MS-DOS (6.22 or higher)
.
The installation and run instructions
in this chapter include both Windows and DOS installation information.
Important!
●
If your PC has Windows installed, setting your Windows SYSTEM.INI and DOS
CONFIG.SYS files with the commands below may help DKBackup run on your PC.
CONFIG.SYS files with the commands below may help DKBackup run on your PC.
SYSTEM.INI
[NonWindowsApp]
[NonWindowsApp]
COMMANDENVSIZE=1024
DOS CONFIG.SYS
SHELL=C:\COMMAND.COM
/e:1024
/p
●
If DKBackup displays a “Run time error” message during installation or operation, erase
all “ntx” files under the customer directory (XXX.DK) and the “data” directory.
all “ntx” files under the customer directory (XXX.DK) and the “data” directory.
Get user manuals:
See SafeManuals.com