TP-LINK AC750 User Manual
RE200
AC750 WiFi Range Extender User Guide
4.3.1 LAN
Selecting Network > LAN will enable you to configure the IP parameters of Network on this page.
Figure 4-3 LAN – Dynamic IP
Figure 4-4 LAN – Static IP
¾
MAC Address - The physical address of the LAN port, as seen from the LAN. The value
cannot be changed.
cannot be changed.
¾
Type - Several IP types are supported, including: (1) Dynamic IP; (2) Static IP, and they are
explained below.
explained below.
z
Dynamic IP - In this type, if your range extender have connected to a router, your client
will dynamically get a IP Address / Gateway from the router, otherwise the client will get a
IP Address / Gateway in the same network as you set below. And this type is
recommended.
will dynamically get a IP Address / Gateway from the router, otherwise the client will get a
IP Address / Gateway in the same network as you set below. And this type is
recommended.
z
Static IP - In this type, you can configure IP Address / Gateway manually.
¾
IP Address - Enter the IP address of your Range Extender in dotted-decimal notation (factory
default setting is 192.168.0.254).
default setting is 192.168.0.254).
¾
Subnet Mask - An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
255.255.255.0 as the subnet mask.
¾
Gateway - The gateway should be in the same subnet as your IP address.
)
Note:
1. The IP parameters cannot be configured if you have chosen Dynamic IP. In this situation the
device will automatically configure the IP parameters appropriate to your need.
15