TP-LINK TD-W8950ND User Manual
TD-W8950ND
150Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-3
¾
VPI/VCI: the VPI and VCI values provided by your ISP. Do not change them unless it was
required by your ISP.
¾
DSL Link Type: Select a DSL Link Type which is provided by your ISP. The options include
EoA (it is for PPPoE, IPoE, and Bridge), PPPoA (PPP over ATM) and IPoA (IP over ATM).
¾
Encapsulation Mode: The mode of the data processing over the Link Type you have
selected. Uses the default setting, if you are not sure.
¾
Service Category: Select the type of the service assigned by your ISP in the drop-down list.
The default type is UBR Without PCR.
)
Note:
Enabling packet level QoS for PVC improves performance for selected classes of applications.
While QoS consumes system resources; therefore the number of PVC(s) will be reduced. Besides
this, it cannot be set for the connection type of CBR and Real-time VBR. If you select the QoS
service, the Quality of Service menu will be added to the Web-based Utility, the detailed
configuration will be described in 4.4.8 Quality of Service.
While QoS consumes system resources; therefore the number of PVC(s) will be reduced. Besides
this, it cannot be set for the connection type of CBR and Real-time VBR. If you select the QoS
service, the Quality of Service menu will be added to the Web-based Utility, the detailed
configuration will be described in 4.4.8 Quality of Service.
4.4.1.2 ETH interface
Choose “Advanced Setup”Æ“Layer2 InterfaceÆETH Interface”, you can configure ETH WAN
interfaces on the screen below.
interfaces on the screen below.
Figure 4-4
)
Note:
To make sure the ETH port available, you should first choose “Advanced Setup”Æ“LAN Ports” to
20