TP-LINK TD-W8910GB User Manual

45 

2.  Enter the following data: 

¾

 

Destination Network Address: The  Destination Network Address is the address of the 
network or host that you want to assign to a static route. 

¾

 

Subnet Mask: The Subnet Mask determines which portion of an IP Address is the network 
portion, and which portion is the host portion. 

¾

 

Gateway IP Address: If the Use Gateway IP Address checkbox is selected, you should 
type the Gateway address exactly in the text box, or else, the default Gateway address will be 
adopted for the Static Route. 

¾

 

Use Interface: If the Use Interface checkbox is selected, you should select the Interface 
name in the text box, or else, the default Use Interface will be adopted for the Static Route. 

3. Click 

the 

Save/Apply button to save it. 

To remove a static routing entry: 
1. Select 

the 

Remove check box according to the entry in the Figure 4-36. 

2. Click 

the 

Remove button, and the entry will be deleted. 

)

Default Gateway IP address should be specified since MER Interface is selected. 

Choose “Advanced Setup”Æ“Routing”Æ“RIP”, you can see the RIP (Routing Information 
Protocol) screen, this screen allows you to configure the RIP (shown in Figure 4-38). 

 

Figure 4-38 

To activate RIP for the device, select the Enabled  radio-button for Global RIP Mode. To 
configure an individual interface, select the desired RIP version and operation, followed by placing 
a check in the Enabled checkbox for the interface. 

If you are sure about the settings, click the Save/Apply button to save the configuration.