TP-LINK TL-MR3420 User Manual

 

 

After a device is successfully added to the network by WPS function, the WPS LED will keep on 
for about 5 minutes and then turn off.

 

 

Figure 1-2    Rear Panel sketch 

The following parts are located on the rear panel (View from left to right). 



  POWER: The Power socket is where you will connect the power adapter. Please use the 

power adapter provided with this TL-MR3420 3G/4G Wireless N Router.   



  ON/OFF: The switch is for you to turn on/off the Router, but only with the Router powered 

on. 



  4,3,2,1 (LAN): These ports (4,3,2,1) connect the Router to the local PC(s) 



  WAN: This WAN port is where you will connect the DSL/cable Modem, or Ethernet   



  WPS/RESET: 

There are two ways to reset to the Router's factory defaults: 

1) Use 

the 

Factory Defaults function on “System Tools -> Factory Defaults” page in 

the Router's Web-based Utility. 

2)  Use the Factory Default Reset button: With the Router powered on, use a pin to press 

and hold the WPS/RESET button (about 5 seconds) until the SYS LED becomes 

quick-flash from slow-flash. And then release the button and wait the Router to reboot 

to its factory default settings. 



  Wireless antenna:    To receive and transmit the wireless data. 

 

Figure 1-3 Side Panel sketch 

The following parts are located on the side plate (View from left to right). 



  WIFI: This switch is an easy and convenient operation for you to turn on or off the wireless 

network. 



  USB: Connect to the USB Modem. 

-4-