TP-LINK TL-SG3424P User Manual

 

103

 

The ping command is used to test the connectivity between the switch and one 

node of the network. 

{ip_addr} [-n {count}] [-l {count}] [-i {count}] 

  ——  The IP address of the destination node for ping test. 

 (-n) —— The amount of times to send test data during Ping testing. It 

ranges from 1 to 10. By default, this value is 4. 

 (-l)  ——  The size of the sending data during ping testing. It ranges from 1 

to 1024 bytes. By default, this value is 64. 

 (-i)  ——    The interval to send ICMP request packets. It ranges from 100 

to 1000 milliseconds. By default, this value is 1000.   

User EXEC Mode and Privileged EXEC Mode   

To test the connectivity between the switch and the network device with the IP 

192.168.0.131, please specify the count (-l) as 512 bytes and count (-i) as 1000 

milliseconds. If there is not any response after 8 times’ Ping test, the connection 

between the switch and the network device is failed to establish: 

192.168.0.131 –n 8 –l 512 

The tracert command is used to test the connectivity of the gateways during its 

journey from the source to destination of the test data. 

 {url} [maxHops] 

  ——  The IP address of the destination device. 

  ——  The maximum number of the route hops the test data can pass 

though. It ranges from 1 to 30. By default, this value is 4.