TP-LINK TL-SG3424P User Manual

 

32

 

leaveall | join | leave —— They are the three timers: leave All、join and leave. 

Once the LeaveAll Timer is set, the port with GVRP enabled can send a 

LeaveAll message after the timer times out, so that other GARP ports can 

re-register all the attribute information. After that, the LeaveAll timer will start to 

begin a new cycle. To guarantee the transmission of the Join messages, a 

GARP port sends each Join message two times. The Join Timer is used to 

define the interval between the two sending operations of each Join message. 

Once the Leave Timer is set, the GARP port receiving a Leave message will 

start its Leave timer, and unregister the attribute information if it does not receive 

a Join message again before the timer times out.   

 ——The value of the timer. The LeaveAll Timer ranges from 1000 to 

30000 centiseconds and the default value is 1000. The Join Timer ranges from 

20 to 1000 centiseconds and the default value is 20. The Leave Timer ranges 

from 60 to 3000 centiseconds and the default value is 60. 

Interface Configuration Mode（interface ethernet / interface range ethernet） 

Set the GARP leaveall timer of port 6 to 2000 centiseconds and restore to the 

join timer of it to the default value: 

 6 

leaveall 2000 

join 

The show gvrp global command is used to to display the global GVRP status.   

Any Configuration Mode 

Display the global GVRP status: