TP-LINK tl-sl5428e User Manual

Page of 259
 
The following entries are displayed on this screen:
 
 
DST Config 
DST Status: 
Enable or Disable DST. 
Predefined Mode: 
Select a predefined DST configuration: 
  USA: Second Sunday in March, 02:00 ~ First Sunday in 
November, 02:00. 
  Australia: First Sunday in October, 02:00 ~ First Sunday in 
April, 03:00. 
  Europe: Last Sunday in March, 01:00 ~ Last Sunday in 
October, 01:00. 
  New Zealand: Last Sunday in September, 02:00 ~ First 
Sunday in April, 03:00. 
Recurring Mode: 
Specify the DST configuration in recurring mode. This 
configuration is recurring in use: 
  Offset: Specify the time adding in minutes when Daylight 
Saving Time comes. 
  Start/End Time: Select starting time and ending time of 
Daylight Saving Time. 
Date Mode: 
Specify the DST configuration in Date mode. This configuration 
is one-off in use: 
  Offset: Specify the time adding in minutes when Daylight 
Saving Time comes. 
  Start/End Time: Select starting time and ending time of 
Daylight Saving Time. 
Note: 
1.  When the DST is disabled, the predefined mode, recurring mode and date mode cannot be 
configured. 
2.  When the DST is enabled, the default daylight saving time is of Europe in predefined mode.   
4.1.5 System IP 
Each device in the network possesses a unique IP Address. You can log on to the Web 
management page to operate the switch using this IP Address. The switch supports three modes 
to obtain an IP address: Static IP, DHCP and BOOTP. The IP address obtained using a new mode 
will replace the original IP address. On this page you can configure the system IP of the switch. 
Choose the menu System→System Info→System IP to load the following page. 
15