Trendnet TW100-BRV324 User Manual

Broadband VPN Gateway User Guide 

Enter a suitable name. This name is not supplied to the remote 
VPN. It is used only to help you manage the policies. 

Enable or disable the policy as required. For each remote VPN, 
only 1 policy can be enabled at any time. 

Select the desired option if you require NetBIOS traffic to be 
transferred through the VPN tunnel. NetBIOS is used by Microsoft 
(Windows) networking. This setting should not be enabled unless 
necessary, because it increases traffic volume. 

Select the desired WAN port as required. 

The Internet IP address of the remote VPN endpoint (Gateway or 
client). 
•  Dynamic IP. Select this if the Internet IP address is unknown. 

In this case, only incoming connections are possible. 

•  Fixed IP. Select this if the remote endpoint has a fixed Internet 

IP address. If selected, enter the Internet IP address of the re-
mote endpoint. 

•  Domain Name. Select this if the remote endpoint has a Do-

main Name associated with it. If selected, enter the Domain 
Name of the remote endpoint. 

•  Any - no additional data is required. Any IP address is accept-

able. 
•  For outgoing connections, this allows any PC on the LAN 

to use the VPN tunnel.  

•  For incoming connections, this allows any PC using the 

remote endpoint to access any PC on your LAN. 

•  Single address - enter an IP address in the "IP address" field. 
•  Range address - enter the starting IP address in the "IP ad-

dress" field, and the finish IP address in the "Finish IP address" 
field. 

•  Subnet address - enter the desired IP address in the "IP 

address" field, and the network mask in the "Subnet Mask" 
field. 

The remote VPN must have these IP addresses entered as it's 
"Remote" addresses. 

•  Single address - enter an IP address in the "IP address" field. 
•  Range address - enter the starting IP address in the "IP ad-

dress" field, and the finish IP address in the "Finish IP address" 
field. 

•  Subnet address - enter the desired IP address in the "IP 

address" field, and the network mask in the "Subnet Mask" 
field. 

The remote VPN should have these IP addresses entered as it's 
"Local" addresses. 

AH (Authentication Header) specifies the authentication protocol 
for the VPN header, if used. (AH is often NOT used) 

78