Tripp Lite PDU6K User Manual
Owner’s Manual
PDU6K Power Distribution Unit (PDU)
for select UPS Systems
Designed for 2U rack and other mounting options
IMPORTANT SAFETY INSTRUCTIONS. This manual contains information
concerning the proper installation and use of Tripp Lite’s Power Distribution
Units (PDUs). SAVE THESE INSTRUCTIONS.
concerning the proper installation and use of Tripp Lite’s Power Distribution
Units (PDUs). SAVE THESE INSTRUCTIONS.
Note: This PDU is intended only for use with select Tripp Lite UPS Systems.
Do not connect your PDU to an ungrounded outlet. Do not use it with extension cords or
adapters that eliminate its connection to ground. Your PDU is designed for indoor use
only. Install it away from heat emitting devices such as radiators and heat registers. Do
not install where excessive moisture or other conductive contaminants are present. Never
install electrical wiring during a lightning storm.
adapters that eliminate its connection to ground. Your PDU is designed for indoor use
only. Install it away from heat emitting devices such as radiators and heat registers. Do
not install where excessive moisture or other conductive contaminants are present. Never
install electrical wiring during a lightning storm.
CAUTION! Outlets are divided into 240V AC and 120V AC types. A total load of 24 amps
can be drawn from the PDU6K. Do not exceed this current rating when connecting
equipment to the PDU6K. If you have any questions, call Tripp Lite Customer Support at
(773) 869-1234.
can be drawn from the PDU6K. Do not exceed this current rating when connecting
equipment to the PDU6K. If you have any questions, call Tripp Lite Customer Support at
(773) 869-1234.
Congratulations! Your PDU6K power distribution unit will add a wide range of electrical outlets to select
Tripp Lite SmartOnline UPS Systems and SmartPro UPS Systems. The PDU6K is equipped with a NEMA
L14-30P plug that should only be connected to the NEMA L-14-30R receptacle on the rear of your UPS.
Tripp Lite SmartOnline UPS Systems and SmartPro UPS Systems. The PDU6K is equipped with a NEMA
L14-30P plug that should only be connected to the NEMA L-14-30R receptacle on the rear of your UPS.
A variety of installation options are available for the
PDU6K including 2U rackmount, wall, under-
console and more. Put four rackmount screws
through star washers and the unit’s mounting clip as
shown (A) and attach to end panel using the pre-
drilled holes.
PDU6K including 2U rackmount, wall, under-
console and more. Put four rackmount screws
through star washers and the unit’s mounting clip as
shown (A) and attach to end panel using the pre-
drilled holes.
Note: The user must determine the fitness of and supply rackmount
screws, bolts or cage nuts required to hold the unit in place before
installation on the desired surface.
screws, bolts or cage nuts required to hold the unit in place before
installation on the desired surface.
Installation
A
2U Recessed Rack Mounting (shown here) allows space for cables.
200306150 PDU6K Owner’s Manual.qxd 7/7/2003 3:00 PM Page 1
Get user manuals:
See SafeManuals.com