Grizzly G0514X User Manual

G0513X/G0514X/G0514X3 Extreme Series Bandsaw

-21-

Figure 14. Quick release tension lever.

Tighten

Loosen

2. Adjust the upper and lower blade guides

away from the blade. Refer to

Adjusting

Blade Guide Bearings on Page 29 for more
details.

3. Open the upper and lower wheel covers, and

slide the blade off of both wheels.

All saw blades are dan-

gerous and may cause

personal injury or death.

Wear leather gloves when

handling.

Table

Figure 15. Mounting the table.

Personal injury may occur

if the table is lifted without

assistance. Get help when

installing the table.

The table is heavy and requires two people to lift
it onto the trunnions. The saw blade should also
be removed to make table installation easier.

Components and Hardware Needed:

Qty

Table .................................................................. 1
Hex Bolts M8-1.25 x 16 ..................................... 4
Lock Washers 8mm ........................................... 4
Flat Washers 8mm ............................................ 4
Table Pin ........................................................... 1
Table Insert ....................................................... 1

To install the table:

1. Loosen blade tension by rotating the quick

release tension lever clockwise as shown in

Figure 14.

4. With the help of another person, lift the table

onto the trunnions.

5. Secure the table to the trunnions as shown

Figure 15 with the supplied hex bolts and

washers.

6. With the blade teeth pointing downward, slide

the blade through the table slot.

7. Slide the blade through the upper and lower

blade guides, and mount it over the upper
and lower wheels.

8. Tighten the quick release tension lever, then

install the table insert and table pin.

9. Keep the upper and lower blade guides

adjusted away from the blade until the blade
tracking and tension have been adjusted.

Trunnions