Grizzly G0514X User Manual

-30-

G0513X/G0514X/G0514X3 Extreme Series Bandsaw

NOTICE

Make sure that the blade teeth will not con-

tact the guide bearings when the blade is

against the rear support bearing during the

cut or the blade teeth will be ruined.

5. Tighten the cap screw on the lateral adjust-

ment rod.

6. Loosen the bearing rotation adjustment cap

screws.

7. Rotate the knurled knob to position the

bearings 0.004" away from the blade.

Note:

0.004" is approximately the thickness of a
dollar bill.

8. Tighten the cap screw to lock the blade guide

bearings in position.

9. Repeat this procedure for the lower guides.

NOTICE

Whenever changing a blade or adjusting ten-

sion and tracking, the upper and lower blade

support bearings and guide bearings must

be properly adjusted before cutting opera-

tions.

Aligning Table

To ensure cutting accuracy when the table is first
installed, the table should be aligned so that the
miter slot is parallel to the bandsaw blade. This
procedure works best with a

⁄

" blade installed.

To align the table so the miter slot is parallel

to the bandsaw blade:

1. Make sure that the blade is tracking prop-

erly and that it is correctly tensioned.

2. DISCONNECT BANDSAW FROM POWER!

3. Loosen the trunnion bolts that secure the

trunnions to the table.

4. Place an accurate straightedge along the

blade. The straightedge should lightly touch
both the front and back of the blade.

Note:

Make sure the straightedge does not go
across a tooth.

5. Use a fine ruler to gauge the distance

between the straightedge and the miter slot.
The distance you measure should be the
same at both the front and the back of the
table (see

Figure 34).

6. Adjust the table as needed for proper align-

ment.

7. Tighten the trunnion bolts.

Figure 34. Measuring for miter slot to be parallel

with blade.