Husqvarna 1200 User Manual
English –
17
25
50
100
300
MAINTENANCE
!
Check the engine’s oil level
19
●
Check the engine’s cooling air inlet
19
●
Check the fuel pump’s air filter
19
●
Check the transmission’s air inlet
20
●
Check the transmission’s oil level
20
●
Check the steering wires
21
●
Check the brakes
22
●
Check the battery
22
●
Check the safety system
22
●
Check screws and nuts
–
❍
Check for fuel and oil leakage
–
❍
Clean the air filter’s pre-filter (foam plastic)
2)
23
●
Check the cutting unit
24
●
Check the tyre pressures (60 kPa)
30
●
Adjust the brakes
22
●
Check the V-belts
–
❍
Change the engine oil
1)
27
●
Lubricate joints and shafts
3)
28
●
Check and adjust the throttle wire
29
●
Replace the air filter’s pre-filter and paper filter
2)
23
●
Replace the oil filter
28
●
Replace the fuel filter
30
●
Replace the plugs
–
❍
Clean the engine’s and the hydrostat’s cooling flanges
2,4)
–
❍
Check the valve clearance
4)
–
❍
Check the valves and seats
4)
–
❍
1)
First change after 8 hours.
2)
During dusty conditions cleaning and replacement should be more frequent.
3)
For daily use of the
machine lubrication should be conducted twice a week.
4)
Conducted by authorised service workshop.
Maintenance interval
in hours
Daily
main-
tenance
before start
Maintenance
Page
●
= Described in these instructions.
❍
= Not described in these instructions.
•
The parking brake is applied.
•
The cutting unit is disengaged.
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
•
The engine is switched off.
•
The ignition key is removed.
•
The ignition cables are removed from the plugs.
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.
are not described in these instructions go to an authorised service workshop.