JVC HR-S5950EU User Manual
Filename [HRS5950EU4-EN.fm]
Masterpage:Left
38
EN
Page 38
December 4, 2001 5:11 pm
SUBSIDIARY SETTINGS (cont.)
* The default setting is bold in the table below.
8
AUTO SP
]
LP TIMER
ON
OFF
OFF
When this function is set to “ON”, the recorder automatically switches to LP
mode to allow complete recording if there is not enough tape to record the
entire programme while timer-recording in SP mode.
For Example . . .
Recording a programme of 210 minutes in length onto a 180-minute tape
mode to allow complete recording if there is not enough tape to record the
entire programme while timer-recording in SP mode.
For Example . . .
Recording a programme of 210 minutes in length onto a 180-minute tape
Make sure you set this function to “ON”, before the timer-recording starts.
NOTES:
● If you have programmed the recorder to timer-record 2 or more programmes, the
second programme and those thereafter may not fit on the tape if you set “AUTO
SP
SP
]
LP TIMER” to “ON”. In this case, make sure the mode is not engaged, then set the
tape speed manually during timer programming.
● In order to ensure that the recording fits on the tape, this feature may leave a slight
non-recorded section at the end of the tape.
● There may be some noise and sound disturbance at the point on the tape where the
recorder switches from SP to LP mode.
● The Auto SP
]
LP Timer feature is not available during ITR (Instant Timer Recording),
and the feature will not work properly with any tapes longer than E-180, or with some
tapes of shorter lengths.
tapes of shorter lengths.
● If you perform timer recording with both VPS/PDC and the Auto SP
]
LP Timer
activated, and the programme goes beyond its originally scheduled length, there may
be times when the programme cannot be recorded in its entirety.
be times when the programme cannot be recorded in its entirety.
8
POWER SAVE
ON
OFF
OFF
When this function is set to “ON”, you can reduce the power consumption
while the recorder is turned off.
while the recorder is turned off.
NOTES:
● During Power Save mode ...
... the front display panel will be turned off.
... the Just Clock function (
... the Just Clock function (
墌
pg. 46) does not work.
... the picture may be distorted momentarily when you turn on/off the recorder.
● Power Save does not work when ...
... the recorder is in the Timer mode.
... the recorder’s power is turned off after timer-recording or Instant Timer Recording.
... “L-2 SELECT” is set to “DECODER” or “SAT” (
... the recorder’s power is turned off after timer-recording or Instant Timer Recording.
... “L-2 SELECT” is set to “DECODER” or “SAT” (
墌
pg. 31).
8
VIDEO STABILIZER
ON
OFF
OFF
When this function is set to “ON”, you can automatically correct vertical
vibration in the picture when playing back unstable recordings made on
another recorder.
vibration in the picture when playing back unstable recordings made on
another recorder.
NOTES:
● When you finish viewing a tape, be sure to set this function to “OFF”.
● Regardless of the setting, this function has no effect during recording and during
special effects playback.
● The on-screen display may jitter vertically when this function is set to “ON”.
● To watch recordings with close-caption, set this function to “OFF”.
Total 210 minutes
Approximately 150 minutes
Approximately 60 minutes
SP mode
LP mode
HRS5950EU1-EN.book Page 38 Tuesday, December 4, 2001 5:32 PM