JVC SR-9240EK User Manual
54
Time
During recording
During standby
1 field
5m sec
GND
Timelapse recording
Camera switching signal
(open-collector output)
(open-collector output)
11-2 Rear Panel’s Input/Output
[CAM SW OUT] camera switching signal output
The CAM SW OUT terminal outputs a camera switching timing signal to the connected sequential switcher. The switching interval
can be set with the <CAM SW> on the VTR mode 1 setting screen. The camera switching signal is output at ground level.
can be set with the <CAM SW> on the VTR mode 1 setting screen. The camera switching signal is output at ground level.
Camera
switching
signal output
timing
switching
signal output
timing
Terminals
Signal levels
Remarks
About 2
seconds
Min. 400 ms
Min. 400 ms
Alarm
Record mode
Record mode
LV: 0 V
Max. 10 mA
Max. 10 mA
LV: 0 V
HV: 5 V ~ 12 V
HV:12 V
(output impedance: 4.7 kohms)
(output impedance: 4.7 kohms)
Record mode:
repeat recording ON/auto rewind ON
repeat recording ON/auto rewind ON
Tape end
Manual
operation
operation
Warning
Warning reset
HV: 12 V
(output impedance: 4.7 kohms)
(output impedance: 4.7 kohms)
Record mode:
repeat recording OFF/auto rewind OFF
repeat recording OFF/auto rewind OFF
ALARM IN
Alarm signal input
Alarm signal input
ALARM REC OUT
Alarm recording
mode signal output
Alarm recording
mode signal output
TAPE END OUT
Tape end signal
output
Tape end signal
output
WARNING/REC
OUT
Warning signal/Rec
mode signal output
OUT
Warning signal/Rec
mode signal output
ALARM RST IN
Alarm signal reset
input
Alarm signal reset
input
Input at ground level
Min. 150 ms
LV: 0 V
CLOCK RESET IN
Clock reset input
Clock reset input
Input at ground level
About 150 ms
LV: 0 V
CLOCK RESET
OUT
Clock reset output
OUT
Clock reset output
Output at ground level
Input at high level
Output at high level
Output at high level
Output at ground level
Other input/output terminal signal levels
11 APPENDIXES
With the <CAM SW>
function menu switch
set to "1 FIELD"
function menu switch
set to "1 FIELD"