Regency E21-NG3 User Manual

 Regency

®

 E21-3 Gas Fireplace Insert

1)  Run the wire through the right or left side 

inlet opening. Be careful not to damage the 
wire.

2)  Connect the wire to the supplied wall switch 

and install into the receptacle box.

Use the Regency Remote Control Kit  approved 
for this unit. Use of other systems may void 
your warranty.

The remote control kit comes with a hand held 
transmitter, a receiver and a wall mounting 
plate.

1)  Choose a convenient location on the wall 

to install the receiver and the receptacle 
box (protection from extreme heat is very 
important). Run wires from the fi replace to 
that location. Use Thermostat Wire Table.

2)  Connect the two wires to the gas valve. See 

diagram below.

3)  Install 3 AAA alkaline batteries in transmitter 

and 4 AA alkaline batteries in  the receiver. 
Install the receiver and its cover in the wall. 
Switch the  remote receiver to "remote" 
mode. The remote control is now ready for 
operation.

A wall thermostat may be installed if desired, 
connect the wires as per the wiring diagram. 
Use table below to determine the maximum 
wire length.

Regency offers an optional programmable 
thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or 
UL approved may be used.

14 GA.
16 GA.
18 GA.
20 GA.
22 GA.

50 Ft.
32 Ft.
20 Ft.
12 Ft.

9 Ft.

Wire Size                       Max. Length