ZyXEL Communications NWA-1100 User Manual
ZyXEL NWA-1100 User’s Guide
187
A
P P E N D I X
I
How to Access and Use the CLI
This chapter introduces the command line interface (CLI).
Accessing the CLI
Use Telnet to access the CLI.
1 Connect your computer to one of the Ethernet ports.
2 Open a Telnet session to the ZyXEL Device’s IP address. If this is your first login, use
2 Open a Telnet session to the ZyXEL Device’s IP address. If this is your first login, use
the default values.
Make sure your computer IP address is in the same subnet, unless you are accessing the
ZyXEL Device through one or more routers. In the latter case, make sure remote
management of the ZyXEL Device is allowed via Telnet.
ZyXEL Device through one or more routers. In the latter case, make sure remote
management of the ZyXEL Device is allowed via Telnet.
Logging in
Use the administrator username and password. If this is your first login, use the default values.
in some ZyXEL Device models you may not need to enter the user name.
in some ZyXEL Device models you may not need to enter the user name.
The ZyXEL Device automatically logs you out of the management interface after five minutes
of inactivity. If this happens, simply log back in again. Use the sys stdio set command
of inactivity. If this happens, simply log back in again. Use the sys stdio set command
to extend the idle timeout. For example, the ZyXEL Device automatically logs you out of the
management interface after 60 minutes of inactivity after you use the sys stdio set 60
management interface after 60 minutes of inactivity after you use the sys stdio set 60
command. Use the sys stdio show command to display the current idle timeout setting.
Table 73 Default Management IP Address
SETTING
DEFAULT VALUE
IP Address
192.168.1.1
Subnet Mask
255.255.255.0
Table 74 Default User Name and Password
SETTING
DEFAULT VALUE
User Name
admin
Password
1234