Ergotech Group 100-D16-B02 Leaflet

 

OCT-08       

                                            

www.ergotechgroup.com

 

 
 
 
 
 
 

 

 

 

•  Add a highlight 

or your point of 
interest here. 

 
•  Add a highlight 

or your point of 
interest here. 

 
•  Add a highlight 

or your point of 
interest here. 

To adjust monitors: 
Laterally: Place hand on bottom of monitor and lift slightly to support weight. Monitor will slide along bar. 

Left/Right and Up/Down:  Grasp monitor with both hands and adjust to desired position. 

To tension the vertical adjustment to the weight of monitor: Tighten the 5mm bolt on the right side of the pivot 

with the hex wrench provided. 

To remove monitor: Take the weight from the monitor with one hand on the bottom and tip back slightly while 

using the other hand to lift the top of the silver release button. Lift up and back and this will release the monitor 

from the stand. 

Product # 100-D16-B02 – Dual Horizontal Desk Stand 

1.  Check to see that small hex set screw at rear of 

base is backed out enough to allow pole to seat 
down completely. Insert pole into base. Tighten set 
screw.  

 
2.  Loosen ratchet type handle on pole clamp with 

horizontal bar (ratchet handle must be on the right 
side of the pole). Slide clamp and assembly over 
pole and tighten handle. 

 

3.  Attach quick release pivots to back of each monitor 

with screws provided. Be sure that silver release 
button is toward the top of the monitor. 

 

4.  Place each monitor on the horizontal bar by tipping 

back approximately 45 degrees and then down 
until the silver release button engages groove and 
clicks down into place.