Apricorn Aegis Bio USB3.0 1TB A25-3BIO256-1000 User Manual

Product codes

A25-3BIO256-1000

Attach the integrated USB cable of

the Aegis Bio to an available USB

port on your computer. The Aegis

Bio LEDs will show Solid

BLUE

and

Flashing

GREEN

indicating that the

drive is ready to enroll your fingerprint.

Swipe your Finger. The

BLUE

LED

will turn off while the

GREEN

LED

starts to flicker briefly as the Aegis Bio

processes your fingerprint.

Wait until the

BLUE

LED turns back

to Solid

BLUE

and the

GREEN

LED

returns to its flashing state.

Continue to repeat Step 2 until both

the

BLUE

and

GREEN

LED are

in a solid state, indicating that your

fingerprint is fully enrolled.
NOTE: The number of attempts will vary depending on the quality of

the fingerprint read. For most people six swipes will be sufficient.
If there is a problem with a fingerprint read, the

BLUE

LED will turn off and

the

RED

LED with start to flash.

To enroll more fingerprints, press the ENROLL button within 15

seconds from your last successful fingerprint enrollment and repeat

the process in steps 2 and 3.
NOTE: A maximum of 5 fingerprints can be stored. There is a 15 second

timeout between entering fingerprints. If the ENROLL button is not pressed

again after the last fingerprint, the unit will assume no more fingerprints will

be entered and return to a standby state.

Once 5 fingerprints have been stored, all three LEDs will turn on. After 2

seconds the

GREEN

and

BLUE

LED will turn off with just the Solid

RED

LED showing. At this point no more fingerprints can be enrolled.

NOTE: Once enrolled, fingerprints cannot be un-enrolled

individually. To remove enrolled fingerprints, a complete re-set

of the drive is required.

Getting Started - Out of the Box

TIP: We highly recommend that you enroll at least three

different fingers to ensure access to the drive in the case

that your primary finger cannot be used.