ZyXEL Wireless Access Point G1000 91-005-124003B User Manual

G-1000 User’s Guide

Chapter 13 LAN Setup

105

The following table describes the fields in this menu.

Enable the roaming feature if you have two or more G-1000s on the same subnet. Follow the 
steps below to allow roaming on your G-1000. 

1 From the main menu, enter 3 to display Menu 3 – LAN Setup.

2 Enter 5 to display Menu 3.5 – Wireless LAN Setup.

3 Move the cursor to the Edit Roaming Configuration field. Press [SPACE BAR] 

to select Yes and then press [ENTER]. Menu 3.5.2 – Roaming Configuration 
displays as shown next. 

Table 44   Menu 3.5.1 WLAN MAC Address Filter

Active

To enable MAC address filtering, press [SPACE BAR] to select Yes and press [ENTER]. 

Filter Action 

Define the filter action for the list of MAC addresses in the MAC address filter table. 
To deny access to the G-1000, press [SPACE BAR] to select Deny Association and press 

[ENTER].  MAC addresses not listed will be allowed to access the router.

The default action, Allowed Association, permits association with the G-1000. MAC 

addresses not listed will be denied access to the router. 

MAC Address Filter

1..32

Enter the MAC addresses (in XX:XX:XX:XX:XX:XX format) of the client computers that are 

allowed or denied access to the G-1000 in these address fields. 

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to cancel” to 

save your configuration or press [ESC] to cancel and go back to the previous screen.

                          Menu 3.5 - Wireless LAN Setup

     Name (SSID)= ZyXEL
     Hide Name (SSID)= No                 Edit MAC Address Filter= No
     Channel ID= CH06 2437MHz             Edit Roaming Configuration= Yes
     RTS Threshold= 2432                  Block Intra-BSS Traffic= No
     Frag. Threshold= 2432                Preamble= Long
     WEP Encryption= Disable              802.11 Mode= Mixed
       Default Key= N/A                   Max. Frame Burst= 0
       Key1= N/A                          Breathing LED= Yes
       Key2= N/A
       Key3= N/A
       Key4= N/A
       Authen. Method= N/A

                    Press ENTER to Confirm or ESC to Cancel: