ZyXEL Wireless Access Point G1000 91-005-124003B User Manual

G-1000 User’s Guide

Chapter 5 System Screens

47

To change your G-1000’s password (recommended), click the SYSTEM link under 
ADVANCED and then the Password tab. The screen appears as shown. This screen allows 
you to change the G-1000’s password.

If you forget your password (or the G-1000 IP address), you will need to reset the G-1000. See 
the 

Resetting the G-1000

 section for details

Figure 12   Password.

The following table describes the labels in this screen.

First DNS Server
Second DNS Server
Third DNS Server

Select From DHCP if your DHCP server dynamically assigns DNS server 

information (and the G-1000's Ethernet IP address). The field to the right 

displays the (read-only) DNS server IP address that the DHCP assigns. 
Select User-Defined if you have the IP address of a DNS server. Enter the 

DNS server's IP address in the field to the right. If you chose User-Defined, but 

leave the IP address set to 0.0.0.0, User-Defined changes to None after you 

click Apply. If you set a second choice to User-Defined, and enter the same IP 

address, the second User-Defined changes to None after you click Apply. 
Select None if you do not want to configure DNS servers. If you do not 

configure a DNS server, you must know the IP address of a machine in order to 

access it.
The default setting is None.

Apply

Click Apply to save your changes back to the G-1000.

Reset

Click Reset to reload the previous configuration for this screen.

Table 9   System General Setup

Table 10   Password

Old Password

Type in your existing system password (1234 is the default password).

New Password

Type your new system password (up to 31 characters). Note that as you type a 

password, the screen displays an asterisk (*) for each character you type.

Retype to Confirm

Retype your new system password for confirmation.

Apply

Click Apply to save your changes back to the G-1000.

Reset

Click Reset to reload the previous configuration for this screen.