IBM Flex System V7000 Storage Node 4939H49 User Manual
Product codes
4939H49
Chapter 5. IBM Flex System V7000 Storage Node Graphical user interface overview
233
Draft Document for Review January 29, 2013 12:52 pm
8068ch05-GUI.fm
5.9.3 Network menu
The network setup for all the interfaces in the cluster is configured here.
Clicking Network opens the window shown in Figure 5-64. From here you can update the
network configuration, set up iSCSI definitions, and view information about the Fibre Channel
connections.
network configuration, set up iSCSI definitions, and view information about the Fibre Channel
connections.
Figure 5-64 Network window
Service IP Addresses
The Service IP’s are IP addresses of each of the two IBM Flex System V7000 Storage Node
controllers called canisters. These controllers have their own IP addresses where several
support actions can be performed. Some of these are listed here:
controllers called canisters. These controllers have their own IP addresses where several
support actions can be performed. Some of these are listed here:
��
Place canister in Service State
��
Power cycle canister
��
Clear all system configuration data
��
Create new cluster
��
Recover a failed system - action ONLY performed by IBM Support
��
Upgrade firmware manually with controllers offline
��
Extract system event logs
Note: The Service IP addresses are normally not used by the IBM Flex System V7000
Storage Node administrator. They are used ONLY as part of the initial installation
procedure or when IBM Support performs certain service actions.
Storage Node administrator. They are used ONLY as part of the initial installation
procedure or when IBM Support performs certain service actions.