ZyXEL Prestige 660RU-T1 91-004-464003B User Manual

Prestige 660RU-Tx Series User’s Guide

Chapter 17 Internet Access

140

Figure 72   Menu 4 Internet Access Setup

The following table contains instructions on how to configure your Prestige for Internet 
access.

Menu 4 - Internet Access Setup

  ISP's Name= MyISP
  Encapsulation= RFC 1483
  Multiplexing= LLC-based
  VPI #= 8
  VCI #= 35
  ATM QoS Type= CBR
    Peak Cell Rate (PCR)= 0
    Sustain Cell Rate (SCR)= 0
    Maximum Burst Size (MBS)= 0
  My Login= N/A
  My Password= N/A
  ENET ENCAP Gateway= N/A
  IP Address Assignment= Static
    IP Address= 0.0.0.0
  Network Address Translation= SUA Only
    Address Mapping Set= N/A

Press ENTER to Confirm or ESC to Cancel:

Menu 4 Internet Access Setup

ISP’s Name

Enter the name of your Internet Service Provider (ISP). This information is for 

identification purposes only.

Encapsulation

Press [

SPACE BAR

] to select the method of encapsulation used by your ISP.  

Choices are PPPoE, PPPoA, RFC 1483 or ENET ENCAP.

Multiplexing

Press [

SPACE BAR

] to select the method of multiplexing used by your ISP. 

Choices are VC-based or LLC-based.

VPI #

Enter the Virtual Path Identifier (VPI) assigned to you. 

VCI #

Enter the Virtual Channel Identifier (VCI) assigned to you.

ATM QoS Type

Press [SPACE BAR] and select CBR (Continuous Bit Rate) to specify fixed 

(always-on) bandwidth. Select UBR (Unspecified Bit Rate) for applications that are 

non-time sensitive, such as e-mail. Select VBR (Variable Bit Rate) for bursty traffic 

and bandwidth sharing with other applications.

Peak Cell Rate 

(PCR)

This is the maximum rate at which the sender can send cells. Type the PCR. 

Sustain Cell Rate 

(SCR)

Sustained Cell Rate is the mean cell rate of a bursty, on-off traffic source that can 

be sent at the peak rate, and a parameter for burst-traffic. Type the SCR; it must be 

less than the PCR.

Maximum Burst 

Size (MBS)

Refers to the maximum number of cells that can be sent at the peak rate. Type the 

MBS. The MBS must be less than 65535.

My Login

Configure the My Login and My Password fields for PPPoA and PPPoE 

encapsulation only. Enter the login name that your ISP gives you. If you are using 

PPPoE encapsulation, then this field must be of the form user@domain where 

domain identifies your PPPoE service name.