ZyXEL Prestige 660RU-T1 91-004-464003B User Manual

Product codes
91-004-464003B
Page of 286
Prestige 660RU-Tx Series User’s Guide
225
Chapter 27 Remote Management
Figure 155   Menu 24.11 Remote Management Control
The following table describes the fields in this menu.
27.2.2  Remote Management Limitations
Remote management over LAN or WAN will not work when:
• A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or 
Web service. 
• You have disabled that service in menu 24.11.
• The IP address in the Secured Client IP field (menu 24.11) does not match the client IP 
address.  If it does not match, the Prestige will disconnect the session immediately.
• There is already another remote management session with an equal or higher priority 
running. You may only have one remote management session running at one time.
Menu 24.11 - Remote Management Control
 TELNET Server:
   Server Port = 23                   Server Access = LAN only
   Secured Client IP = 0.0.0.0
 FTP Server:
   Server Port = 21                   Server Access = LAN only
   Secured Client IP = 0.0.0.0
 Web Server:
   Server Port = 80                   Server Access = LAN only
   Secured Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
Table 70   Menu 24.11 Remote Management Control
FIELD
DESCRIPTION
Telnet Server
FTP Server        
Web Server    
Each of these read-only labels denotes a service or protocol.
Port
This field shows the port number for the service or protocol. You may change the 
port number if needed, but you must use the same port number to access the 
Prestige.
Access
Select the access interface (if any) by pressing the [SPACE BAR]. Choices are: 
LAN onlyWAN onlyAll or Disable. The default is LAN only.
Secured Client IP The default 0.0.0.0 allows any client to use this service or protocol to access the 
Prestige. Enter an IP address to restrict access to a client with a matching IP 
address.
When you have completed this menu, press [ENTER] at the prompt “
Press ENTER to Confirm 
or ESC to Cancel:
”  to save your configuration, or press [ESC] at any time to cancel.