Panasonic PT-DZ680ULS User Manual
20 - ENGLISH
Chapter 1 Preparation — About your projector
About your projector
Remote control
)URQW
7RS
%RWWRP
1 Remote control indicator
Flashes if any button in the remote control is pressed.
2 Power standby <v> button
Sets the projector to the standby mode when the <MAIN
POWER> switch on the projector is set to <ON>.
3 Power on <b> button
Starts projection when the <MAIN POWER> switch on the
projector is set to <ON> and the power is switched off (standby
mode).
4 Input selection (<RGB1>, <RGB2>, <DVI-D>, <VIDEO>,
<S-VIDEO>, <HDMI>) buttons
Switches the input signal to project. (x page 46)
5 <MENU> button/<ENTER> button/asqw buttons
Used to operate the menu screen. (x page 49)
6 <ON SCREEN> button
Switches the on-screen display function on (displayed)/off
(hidden). (x page 45)
7 <TEST PATTERN> button
Displays the test pattern. (x page 47)
8 Number (<0> - <9>) buttons
Used when the system uses multiple projectors.
Used to input ID numbers or passwords.
9 <STATUS> button
Displays the projector information.
10 <AUTO SETUP> button
Automatically adjusts the image display position while projecting
the image.
[PROGRESS] is displayed on the screen while the image is
adjusted automatically. (x page 46)
11 <SHUTTER> button
Use to temporarily turn off the image. (x page 45)
12 <ASPECT> button
Switches the aspect ratio of the image. (x page 47)
13 Lens (<FOCUS>, <ZOOM>, <SHIFT>) buttons
Adjusts the projection lens. (x pages 41, 43)
14 <FUNCTION> button
You can assign a frequently used operation as a shortcut button.
(x page 47)
15 <DEFAULT> button
Resets the content of the sub-menu to the factory default.
(x page 49)
16 <ID SET> button
Sets the ID number of the remote control when a system uses
multiple projectors. (x page 23)
17 <ID ALL> button
Use to simultaneously control all the projectors with one remote
control when a system uses multiple projectors. (x page 23)
18 Remote control signal transmitter
19 Remote control wired terminal
19 Remote control wired terminal
Connecting to the projector with a cable
(x page 24)
Attention
r
f
Do not drop the remote control.
r
f
Avoid contact with liquids or moisture.
r
f
Do not attempt to modify or disassemble the remote control.
Note
r
f
The remote control can be used within a distance of about 30 m (98'5") if pointed directly at the remote control receiver. The remote control
can control at angles of up to ±15° vertically and ±30° horizontally, but the effective control range may be reduced.
r
f
If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.
r
f
The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.
r
f
If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly.
Use it in a place distant from the light source.
r
f
The power indicator <ON (G)/STANDBY (R)> will flash if the projector receives a remote control signal.