Panasonic PT-DZ680ULS User Manual
40 - ENGLISH
Chapter 3 Basic Operation — Switching on/off the projector
Power indicator
Displays the status of the power. Check the <ON (G)/STANDBY (R)> status of the power indicator before operating the projector.
3RZHULQGLFDWRU 21 * 67$1'%< 5 !
Indicator status
Status
No illumination or flashing
The main power is switched off.
Red
Lit
The power is switched off. (Standby mode.)
Projection will start if the power on <b> button is pressed.
r
f
The projector may not operate when the lamp indicators <LAMP1>/<LAMP2> or
temperature indicator <TEMP> is flashing. (x page 108)
Green
Lit
Projecting.
Orange
Lit
The projector is preparing to switch off the power.
The power is switched off after a while. (Changes to the standby mode.)
Note
r
f
When the power indicator <ON (G)/STANDBY (R)> lamp is lit in orange, the fan is turning and the projector is cooling.
r
f
The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> is lit in red).
Refer to “Power consumption” (x page 125) for the power consumption.
Refer to “Power consumption” (x page 125) for the power consumption.
r
f
The power indicator <ON (G)/STANDBY (R)> will flash in green if a remote control signal is received.
r
f
The power indicator <ON (G)/STANDBY (R)> will flash slowly in green while the shutter is closed. (x page 45)
r
f
If the power indicator <ON (G)/STANDBY (R)> is flashing in red, consult your dealer.
Switching on the projector
3)
3)
2)
1)
To use a projection lens that is an optional accessory, attach the lens before switching on the projector. (x page 33)
Remove the lens cover first.
Remove the lens cover first.
1)
Connect the power plug to an outlet.
r
f
(AC 120 V 50 Hz/60 Hz)
2)
Press the <ON> side of the <MAIN POWER>
switch to turn on the power.
r
f
The power indicator <ON (G)/STANDBY (R)> will light in red,
and the projector will enter the standby mode.
3)
Press the power on <b> button.
r
f
The power indicator <ON (G)/STANDBY (R)> will light in green
and the image will soon be projected on the screen.
Note
r
f
If the projector is switched on at about 0 °C (32 °F), a warm-up period of approximately five minutes may be necessary until a projection is
displayed.
The temperature indicator <TEMP> is lit during the warm-up period. When the warm-up is completed, the temperature indicator <TEMP>
The temperature indicator <TEMP> is lit during the warm-up period. When the warm-up is completed, the temperature indicator <TEMP>
turns off and the projection starts. Refer to “Managing the indicated problems” (x page 108) for the indicator status.
r
f
If the operating environment temperature is low and warm-up takes more than 5 minutes, the projector will judge that a problem has
occurred and the power will automatically be set to stand-by. If this happens, increase the operating environment temperature to 0 °C (32 °F)