Panasonic PT-DZ680ULS User Manual
ENGLISH - 63
Chapter 4 Settings — [ADVANCED MENU] menu
Blanking correction
Item
Operation
Adjustment
Range
Left side of the screen
[LEFT]
Press w.
The blanking zone
moves to the right.
0 to 959
Press q.
The blanking zone
moves to the left.
Right side of the
screen
[RIGHT]
Press w.
The blanking zone
moves to the right.
Press q.
The blanking zone
moves to the left.
[INPUT RESOLUTION]
You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.
1)
Press as to select [INPUT RESOLUTION].
2)
Press the <ENTER> button.
r
f
The
[INPUT RESOLUTION] screen is displayed.
3)
Press as to select [TOTAL DOTS], [DISPLAY
DOTS], [TOTAL LINES], or [DISPLAY LINES],
then press qw to adjust it.
r
f
Values corresponding to the input signal are displayed
automatically for each item. Change the displayed values and
adjust to the optimal image viewing the screen when there is a
vertical banding or missing in the screen.
Note
r
f
Previously mentioned vertical banding will not occur with all white signal input.
r
f
The image may be disrupted while performing the adjustment, but it is not a malfunction.
r
f
[INPUT RESOLUTION] can be adjusted only when an RGB signal is input to the <RGB 1 IN> terminal or the <RGB 2 IN> terminal.
r
f
Certain signals may not be adjustable.
[CLAMP POSITION]
You can adjust the optimal point when the black part of the image is blunt or it has turned green.
1)
Press as to select [CLAMP POSITION].
2)
Press qw to adjust.
r
r
Adjustment details
Status
Rough guide for optimal value
Range
The black part is blunt.
The point where bluntness of the black part improves the most
is the optimal value.
1 - 255
The black part is green.
The point where the green part becomes black, and the
bluntness improves is the optimal value.
Note
r
f
[CLAMP POSITION] can be adjusted only when a signal is input to the <RGB 1 IN> terminal or the <RGB 2 IN> terminal.
r
f
Certain signals may not be adjustable.
[EDGE BLENDING]
The edge blending function allows multiple projector images to be seamlessly overlapped by using the inclination of the brightness at the
overlapped area.
1)
Press as to select [EDGE BLENDING].
2)
Press qw to switch [EDGE BLENDING].
r
f
The setting will change between [ON] and [OFF] each time you
press the button.
r
f
To adjust edge blending, proceed to Step
3).
3)
Press the <ENTER> button when [ON] is
selected.
r
f
The
[EDGE BLENDING] screen is displayed.
4)
Press as to specify the location to be
corrected.
r
f
When joining at top: Set [UPPER] to [ON].
r
f
When joining at bottom: Set [LOWER] to [ON].
r
f
When joining at left: Set [LEFT] to [ON].
r
f
When joining at right: Set [RIGHT] to [ON].
5)
Press qw to switch between [ON] and [OFF].
r
f
To adjust edge blending without displaying the adjustment
marker, proceed to Step
8).
6)
Press as to select [MARKER].